Results 1 to 4 of 4

Thread: Corona v2 messed up board!

  1. #1
    Join Date
    Oct 2011
    Posts
    8
    Rep Power
    15

    Default Corona v2 messed up board!

    So i recently tried the sd card nand dump method, which i believe i got the 16mb nand to dump properly, but i had the 68 ohm resistor soldered directly to the board. It wasn't until to late that I found out that was a mistake, it ripped the pad right out of the board. I've tried repairing the connection by cutting away at the contacts and connecting them with wire but the xbox doesn't turn on anymore it just beeps I even checked it with a multimeter for continuity and it seemed to be alright but still nothing, any help?

  2. #2
    Join Date
    Oct 2008
    Posts
    3,179
    Rep Power
    166

    Default Re: Corona v2 messed up board!

    Post Pictures of the damage...

    This may help


    http://www.xbox360iso.com/usa-colorado-mods-t595279.html

  3. #3
    Join Date
    Oct 2011
    Posts
    8
    Rep Power
    15

    Default Re: Corona v2 messed up board!

    These are pictures of my attempted fixes to the damaged area, I can remove the wire and show you underneath if you need. I guess in my original post I forgot to mention I did the same thing to the FT1R4 point with the resistor, I'm a little bit of a noob.
    Last edited by frankfiller; 5th March 2015 at 06:51 AM.

  4. #4
    Join Date
    Oct 2011
    Posts
    8
    Rep Power
    15

    Default Re: Corona v2 messed up board!

    Can you see the pictures, I was having trouble putting them up earlier.

Similar Threads

  1. Looking for cheapest dual nand board and Glitch board, Suggestions?
    By Antman1 in forum Reset Glitch General Chat
    Replies: 3
    Last Post: 6th September 2014, 12:54 AM
  2. Replies: 0
    Last Post: 7th July 2014, 06:12 PM
  3. New Corona v6 Board is not RGH compatiebel
    By knarfboy in forum Xbox News
    Replies: 19
    Last Post: 4th May 2014, 01:57 PM
  4. Nid help on my corona board matrix chip jtag
    By hotjiro in forum JTAG/RGH Help
    Replies: 2
    Last Post: 23rd May 2013, 07:14 PM
  5. Jasper Board (Messed a point....)
    By Manmeet in forum JTAG/RGH Help
    Replies: 5
    Last Post: 29th November 2012, 06:36 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Please contact us for your DMCA OR Abuse Requests via
dmca@xbox360iso.com
Xbox360ISO website is not endorsed by or affiliated with Xbox and/or Microsoft Corporation.
eXTReMe Tracker